- RE's New Capitalist Venture

RE · Dec 15, 2024, 07:07 PM

I spoke too soon. More failures.

After finishing the starter roll of filament with a couple of successful prints, I put in a new roll of PLA filament, and so far after half a dozen attempts have yet to get it to adhere to the build plate at all. Not even getting a partial print.

Flashforge refused to exchange the printer for the A4P model, so I accepted their offer to send me a new nozzle with a .4mm stream, up from the current .25mm. It will take a while to get here. Meanwhile I will experiment with making some manual adjustments and see if there is another stickier adhesive available to try.

Collapse will probably arrive here on the Last Great Frontier before I have my prototypes done.

RE

- RE's New Capitalist Venture

RE

This is a

new Diner page